Rapid setting water plugging system

Description

RonaStop Water Plug is used to stop the flow of water seeping or running through concrete or brickwork and other building surfaces.

 

Supplied as a fine powder it is mixed with water to produce a putty or dough-like consistency which can be kneaded and shaped by hand. It must be hand mixed close to the area of use and is only used in small volume.

 

Once mixed the material will harden within seconds or minutes, depending on the temperature of the RonaStop Water Plug top and the water and the amount mixed, and must therefore be mixed close to the area of application.

Quick Question?







Our Product range

DRYING OF SCREEDS

BS 8204-1 “Concrete bases and cementitious levelling screeds to receive floorings — Code of practice” section 6.11.1 suggests the following calculation for drying of screeds with no fast drying additi ...

Read more

AVOIDANCE/ MITIGATION OF THE EFFECTS OF COMMON FORMS OF CRACKING IN CEMENTITIOUS SCREEDS

Aggregate is usually 0–4 mm and is mixed with cement in the ratio of 1:3 or 1:4 cement to sand, depending on strength requirements and drying requirements. For total screed thicknesses in excess of 50 ...

Read more

Carbonation of Reinforced Concrete

Carbonation is the single most common cause of reinforcement corrosion in above ground structures and although many construction professionals and contractors are familiar with the progression of carb ...

Read more

Here to help...